For cisco ios, which escape sequence allows terminating a traceroute operation?

FOR CISCO IOS, WHICH ESCAPE SEQUENCE ALLOWS TERMINATING A TRACEROUTE OPERATION? CODE

Starting LSP Path Discovery for 1.1.1.4/32 MPLS Tree Trace for Prefix-SID RP/0/ RP0 /CPU0:router-arizona# traceroute mpls multipath ipv4 1.1.1.4/32

MPLS Traceroute for Prefix-SID RP/0/ RP0 /CPU0:router-arizona# traceroute mpls ipv4 1.1.1.4/32 Success rate is 100 percent (5/5), round-trip min/avg/max = 2/2/3 ms

FOR CISCO IOS, WHICH ESCAPE SEQUENCE ALLOWS TERMINATING A TRACEROUTE OPERATION? CODE

'X' - unknown return code, 'x' - return code 0 'R' - transit router, 'I' - unknown upstream index, 'P' - no rx intf label prot, 'p' - premature termination of LSP, 'M' - malformed request, 'm' - unsupported tlvs, 'N' - no rx label, 'D' - DS Map mismatch, 'F' - no FEC mapping, 'f' - FEC mismatch,

'L' - labeled output interface, 'B' - unlabeled output interface, Timeout is 2 seconds, send interval is 0 msec:Д¬odes: '!' - success, 'Q' - request not sent, '.' - timeout, These examples use the following topology: MPLS Ping for Prefix-SID RP/0/ RP0 /CPU0:router-arizona# ping mpls ipv4 1.1.1.4/32 Examples: MPLS Ping, Traceroute, and Tree Trace for Prefix-SID

The BGP IPv4 prefix sub-TLV contains the prefix SID and the prefix length. The prefix length, and the protocol (IS-IS or OSPF). The IGP IPv4 prefix sub-TLV contains the prefix SID, The BGP and IGP IPv4 prefix sub-TLV has been added to the Target FEC Stack sub-TLV. The Target FEC sub-TLVs are used by the responder for FEC validation. MPLS echo request packets carry Target FEC Stack sub-TLVs. This operation is performed repeatedly for each hop of each path with increasing TTL values until Returns the list of downstream paths, as well as the multipath information that can lead the operator to exercise each path When the packet TTL expires at the responding node, the node Information that may allow the originator to exercise each ECMP. It uses multipath data encoded in echo request packets to query for the load-balancing Of an LSP to reach a destination Prefix SID. MPLS LSP Tree Trace provides the means to discover all possible equal-cost multipath (ECMP) routing paths The MPLS LSP Tree Trace (traceroute multipath) operation is also supported for BGP and IGP Prefix SID. If the echo message is passed to the control plane,ДЄ reply message is generated based on the contents of the request message. The packet is passed to the control plane, else the message is forwarded. When the MPLS echo request message hits a transit node, it checks the TTL value and if it is expired, The MPLS LSP Traceroute feature relies on the expiration of the Time to Live (TTL) value of the packet thatД¬arries the echo request. It is used for hop-by-hop fault localizationДЄnd path tracing. The MPLS LSP Traceroute feature is used to isolate the failure point of an LSP. The IP packet from being IP switched to its destination, if the LSP is broken. The destination IP address is defined as a 127.x.y.z/8 address and it prevents The address used to select the label stack. The destination IP address of the MPLS echo request packet is different from Request and reply messages, to validate an LSP. MPLS LSP ping uses MPLS echo request and reply messages, similar to Internet Control Message Protocol (ICMP) echo The MPLS LSP Ping feature is used to check the connectivity between ingress Label Switch Routers (LSRs) and egress LSRs alongДЄn LSP. Route redistribution from IS-IS to OSPF and from OSPF to IS-ISД¬ombinations of BGP and LDP signaled LSPs MPLS Ping and Traceroute operations for Prefix SID are supported for various BGP and IGP scenarios, for example: MPLS Ping and Traceroute for BGP and IGP Prefix-SID

Segment Routing Ping and Traceroute for Flexible Algorithm.

Examples: LSP Ping and Traceroute for Nil_FEC Target.

MPLS LSP Ping and Traceroute Nil FEC Target.

Examples: MPLS Ping, Traceroute, and Tree Trace for Prefix-SID.

MPLS Ping and Traceroute for BGP and IGP Prefix-SID.

Routing OAM feature provides support for BGP prefix SIDs, IGP prefix SIDs, and Nil-FEC (forwarding equivalence classes) LSP Ping and Traceroute functionality. (LSPs) and quickly isolate forwarding problems to assist with fault detection and troubleshooting in the network. Segment Routing Operations, Administration, and Maintenance (OAM) helps service providers to monitor label-switched paths

For cisco ios, which escape sequence allows terminating a traceroute operation?